5 Telltale Signs Something Is Wrong with Your Water Heater

It should be quite easy to tell when something is wrong with your water heater, right? Well, not necessarily. Some malfunctions aren’t always obvious, but the consequences of an undetected defect or fault can be catastrophic. That’s why it’s important to know how to recognize the signs that something might be wrong.

Buckle up because we’re about to dive into water heater maintenance 101. Not only that we’ll present the most common signs that your water heater is about to fail, but we will also tell you what to do if something is wrong.

It Doesn’t Heat the Water Properly 

The most obvious sign that your heater is not properly functioning is when the hot water becomes lukewarm, or it fluctuates. In most cases, a mineral build-up at the bottom of the water tank is the cause of this problem, especially if you live in an area where the water is hard. When too much mineral sediments collect at the bottom of the tank, they prevent the heating system from doing its job.

If you suspect a mineral build up, then it’s a good idea to have a professional come and have a look. That is the type of issue that can easily escalate into a big problem. Because the system is overworking to heat the water, it can malfunction when you least expect it.

It Makes Strange Noises

While a certain level of noise is to be expected from your heater, you should check any popping, creaking or rumbling sounds. Once again, the culprit might be a mineral build-up. The mineral deposits trap little pockets of air that react to the high temperature.

If you are lucky and catch the problem early on, then flushing the water should be enough to fix it. Otherwise, you might have to replace Winnipeg water heaters altogether.

It Leaks Water

You don’t have to be an expert to know that water leakage is never a good sign. If you notice a leak, then it means that the oozing component is either weakening or malfunctioning. How you address this problem depends on the component.

For example, if the tank is the one leaking, then it may be a sign of corrosion. So, make it a habit to check your water heater periodically for signs of decay. If the pressure valve is the one leaking, then you should pick up the phone and call a professional immediately. A faulty pressure valve is a ticking bomb and a threat to your safety.

320143584 217676537b b

The Water Has a Modified Look, Taste or Smell

Even if the water heater itself seems fine, noticing something weird about the tap water can signal a problem. Unusual signs include cloudy water, metallic smelling water, rusty water, and even a metallic taste. Most of the times, the cause of these changes in the water properties is a mineral deposit. It can also be rust.

It is important to find out what component is malfunctioning and causing the problem. If you have the same problem with the cold water as well, the house pipes might be the ones to blame. Try replacing them as soon as you can to prevent any future damage. If you notice the funky smell when you turn on the hot water, have a professional investigate the heater as soon as possible.

The Water Pressure Is Low

Low water pressure can be the result of mineral deposits that make the pipes narrower, but it could also mean a faulty design or poor installation. Call in a professional to investigate the problem and suggest the best solution.

The bottom line is that the best way to prevent most of the potential problems with your water heaters is to maintain it thoroughly. Flushing it monthly, checking it annually and closely monitoring it will get it to work properly for years to come.

Home of Ohm © Copyright 2022. All rights reserved.